Big B
New Member
Posts: 16
Loc: St. Louis, MO, USA
Reg: 12-07-04
|
 12-08-04 03:04 AM - Post#54512
I have a Heli-Max Governor (HMXM1500). Does anyone have any information that they might share about this unit.
|
alexander
Senior Member
Posts: 921
Reg: 12-20-02
|
 12-09-04 09:40 PM - Post#54697
In response to Big B
try our web site governor page at:
http://www.scotiabladerunners.ca/techmanparts.html
Keep in mind it is a very old review and intended for the average sport flyer into loops and rolls.It does not compare well to the stuff available today.
Stephen
|
Big B
New Member
Posts: 16
Loc: St. Louis, MO, USA
Reg: 12-07-04
|
12-14-04 03:46 AM - Post#54965
In response to alexander
Stephen,
Thank's!
This provides a little more insite to setup and use. Still having problems with whether or not I really need an aux channel to switch the unit on and off and if I really need two settings. Thought I would only need governor in idle-up and not in normal mode. Hopefully I can set it up so going to idle-up turns it on and going to normal mode and throttle-hold turns it off. I believe I will learn all this when I start setting it up.
Thanks again,
Big B
|
alexander
Senior Member
Posts: 921
Reg: 12-20-02
|
12-14-04 02:56 PM - Post#54991
In response to Big B
Do you have the factory instructions?
Stephen
|
Big B
New Member
Posts: 16
Loc: St. Louis, MO, USA
Reg: 12-07-04
|
12-15-04 02:38 AM - Post#55026
In response to alexander
Yes, I have.
|
alexander
Senior Member
Posts: 921
Reg: 12-20-02
|
12-15-04 02:54 PM - Post#55055
In response to Big B
Did you know that the throttle Jockey and the Helimax sensors are interchangable?
cheers,
Stephen
|
