jmkirsch
New Member
Posts: 4
Loc: Rochester, NY
Reg: 07-01-02
|
 07-03-02 11:04 PM - Post#8974
In response to Staff
In the Raptor 30, an M3x14 socket screw holds the mixing lever into the flybar seesaw hub. A collar is placed over this screw for the bearings to run on, but there is a small amount of play between the screw and the collar. This creates a bit of slop, and can easily be eliminated by wrapping some teflon plumbing tape around the socket screw.
|
