WildMisterT
Member
Posts: 97
Loc: Canada
Reg: 06-17-03
|
 07-21-03 04:32 PM - Post#23314
In response to Staff
To balance my Main Rotor Head+Flybar+Paddles, I remove the Head and Shaft from the Heli and put it into a PowerDrill, secure the shaft as a drill bit, then select the proper direction, hold the drill vertical over my head and spin the rotor.
That way I was able to troubbleshoot a vibration problem I had. Now be shure to tight the shaft properly, you don't want the rotor to fly off the drill...be carefull.You will see and feel the vibration if any, then ajust paddles, flybar, etc...
| Don't Drink and Fly... ;) |
|
